Whichboot, Automatic code upgrade commands, Upgrade opcode auto – LevelOne GTL-2691 User Manual
Page 785: Whichboot 785
C
HAPTER
24
| System Management Commands
File Management
– 785 –
whichboot
This command displays which files were booted when the system powered
up.
S
YNTAX
whichboot [unit]
unit - Stack unit. (Range: 1-8)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description of the
file information displayed by this command.
Console#whichboot
File Name Type Startup Modify Time Size(bytes)
-------------------------------- ------- ------- ------------------- -----------
Unit 1:
GTL-2691_Op_V1.4.2.10.bix OpCode Y 2012-05-09 09:38:49 15285876
startup1.cfg Config Y 2012-10-19 05:48:13 2499
Console#
Automatic Code Upgrade Commands
upgrade opcode
auto
This command automatically upgrades the current operational code when a
new version is detected on the server indicated by the
command. Use the no form of this command to restore the default
setting.
S
YNTAX
[no] upgrade opcode auto
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
This command is used to enable or disable automatic upgrade of the
operational code. When the switch starts up and automatic image
upgrade is enabled by this command, the switch will follow these steps
when it boots up: