LevelOne GTL-2691 - Manual (Page 843)

C HAPTER 25 | SNMP Commands
Notification Log Commands
– 843 –
Notification Log Commands
nlm This command enables or disables the specified notification log.
S YNTAX
[no] nlm filter-name
filter-name - Notification log name. (Range: 1-32 characters)
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ Notification logging is enabled by default, but will not start recording
information until a logging profile specified by the snmp-server
notify-filter command is enabled by the nlm command.
◆ Disabling logging with this command does not delete the entries stored
in the notification log.
E XAMPLE
This example enables the notification log A1.
Console(config)#nlm A1
Console(config)#
snmp-server
notify-filter
This command creates an SNMP notification log. Use the no form to
remove this log.
S YNTAX
[no] snmp-server notify-filter profile-name remote ip-address
profile-name - Notification log profile name. (Range: 1-32
characters)
ip-address - The Internet address of a remote device. The specified
target host must already have been configured using the snmp-
server host command.
N OTE :
The notification log is stored locally. It is not sent to a remote
device. This remote host parameter is only required to complete
mandatory fields in the SNMP Notification MIB.
D EFAULT S ETTING
None