LevelOne GTL-2691 - Manual (Page 823)

C HAPTER 24 | System Management Commands
Switch Clustering
– 823 –
cluster ip-pool This command sets the cluster IP address pool. Use the no form to reset to
the default address.
S YNTAX
cluster ip-pool ip-address
no cluster ip-pool
ip-address - The base IP address for IP addresses assigned to
cluster Members. The IP address must start 10.x.x.x.
D EFAULT S ETTING
10.254.254.1
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ An “internal” IP address pool is used to assign IP addresses to Member
switches in the cluster. Internal cluster IP addresses are in the form
10.x.x.member-ID. Only the base IP address of the pool needs to be
set since Member IDs can only be between 1 and 16.
◆ Set a Cluster IP Pool that does not conflict with addresses in the
network IP subnet. Cluster IP addresses are assigned to switches when
they become Members and are used for communication between
Member switches and the Commander.
◆ You cannot change the cluster IP pool when the switch is currently in
Commander mode. Commander mode must first be disabled.
E XAMPLE
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#
cluster member This command configures a Candidate switch as a cluster Member. Use the
no form to remove a Member switch from the cluster.
S YNTAX
cluster member mac-address mac-address id member-id
no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch.
(Range: 1-16)
D EFAULT S ETTING
No Members