LevelOne GTL-2691 - Manual (Page 1257)

C HAPTER 42 | Multicast Filtering Commands
MVR for IPv6
– 1257 –
C OMMAND M ODE
Privileged Exec
E XAMPLE
The following displays information about the interfaces attached to the
MVR VLAN in domain 1:
Console#show mvr6 domain 1 interface
MVR6 Domain : 1
Port Type Status Immediate Static Group Address
-------- -------- ------------- --------- -------------------------
Eth1/ 1 Source Active/Up
Eth1/ 2 Receiver Active/Up Disabled FF00::1(VLAN2)
Console#
show mvr6
members
This command shows information about the current number of entries in
the forwarding database, or detailed information about a specific multicast
address.
S YNTAX
show mvr6 [domain domain-id] members [ip-address]
domain-id - An independent multicast domain. (Range: 1-5)
ip-address - IPv6 address for an MVR multicast group.
D EFAULT S ETTING
Displays configuration settings for all domains and all forwarding entries.
C OMMAND M ODE
Privileged Exec
Table 156: show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source
ports is “ACTIVE” if MVR is globally enabled on the switch. MVR status
for receiver ports is “ACTIVE” only if there are subscribers receiving
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.
Immediate Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR group assigned to an interface, and the receiver
VLAN.