LevelOne GTL-2691 - Manual (Page 89)

C HAPTER 2 | Initial Switch Configuration
Basic Configuration
– 89 –
running a different image version. For information on downloading
firmware, see “Managing System Files” on page 123.
B ASIC C ONFIGURATION
C ONSOLE
C ONNECTION
The CLI program provides two different command levels — normal access
level (Normal Exec) and privileged access level (Privileged Exec). The
commands available at the Normal Exec level are a limited subset of those
available at the Privileged Exec level and allow you to only display
information and use basic utilities. To fully configure the switch
parameters, you must access the CLI at the Privileged Exec level.
N OTE :
You can only access the console interface through the Master unit in
the stack.
Access to both CLI levels are controlled by user names and passwords. The
switch has a default user name and password for each level. To log into the
CLI at the Privileged Exec level using the default user name and password,
perform these steps:
1.
To initiate your console connection, press . The “User Access
Verification” procedure starts.
2. At the Username prompt, enter “admin.”
3. At the Password prompt, also enter “admin.” (The password characters
are not displayed on the console screen.)
4. The session is opened and the CLI displays the “Console#” prompt
indicating you have access at the Privileged Exec level.
S ETTING P ASSWORDS
If this is your first time to log into the CLI program, you should define new
passwords for both default user names using the “username” command,
record them and put them in a safe place.
Passwords can consist of up to 8 alphanumeric characters and are case
sensitive. To prevent unauthorized access to the switch, set the passwords
as follows:
1. Open the console interface with the default user name and password
“admin” to access the Privileged Exec level.
2. Type “configure” and press .
3. Type “username guest password 0 password,” for the Normal Exec
level, where password is your new password. Press .