LevelOne GTL-2691 - Manual (Page 1085)

C HAPTER 37 | Spanning Tree Commands
– 1085 –
E XAMPLE
Console#spanning-tree loopback-detection release ethernet 1/1
Console#
spanning-tree
protocol-migration
This command re-checks the appropriate BPDU format to send on the
selected interface.
S YNTAX
spanning-tree protocol-migration interface
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-32)
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
If at any time the switch detects STP BPDUs, including Configuration or
Topology Change Notification BPDUs, it will automatically set the selected
interface to forced STP-compatible mode. However, you can also use the
spanning-tree protocol-migration command at any time to manually
re-check the appropriate BPDU format to send on the selected interfaces
(i.e., RSTP or STP-compatible).
E XAMPLE
Console#spanning-tree protocol-migration eth 1/5
Console#