LevelOne GTL-2691 - Manual (Page 1255)

C HAPTER 42 | Multicast Filtering Commands
MVR for IPv6
– 1255 –
E XAMPLE
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/2
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 2 group ff00::1
Console(config-if)#
show mvr6 This command shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current number of group
addresses, and the upstream source IP address.
S YNTAX
show mvr6 [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
D EFAULT S ETTING
Displays configuration settings for all MVR domains.
C OMMAND M ODE
Privileged Exec
E XAMPLE
The following shows the MVR settings:
Console#show mvr6
MVR6 Proxy Switching : Enabled
MVR Robustness Value : 1
MVR6 Proxy Query Interval : 125(sec.)
MVR6 Source Port Mode : Always Forward
Domain : 1
MVR6 Config Status : Disabled
MVR6 Running Status : Inactive
MVR6 Multicast VLAN : 1
MVR6 Current Learned Groups : 0
MVR6 Upstream Source IP : FF05::25
.
.
.
Table 155: show mvr6 - display description
Field Description
MVR6 Proxy Switching Shows if MVR proxy switching is enabled
MVR6 Proxy Query
Interval
The interval at which the receiver port sends out general queries
MVR6 Source Port
Mode
Shows if the switch only forwards multicast streams which the
source port has dynamically joined or always forwards multicast
streams
MVR Robustness Value Shows the number of reports or query messages sent when proxy
switching is enabled