Enabling the server, Setting excluded addresses, Figure 364: enabling the dhcp server – LevelOne GTL-2691 User Manual
Page 605
C
HAPTER
17
| IP Services
Dynamic Host Configuration Protocol
– 605 –
E
NABLING
THE
S
ERVER
Use the IP Service > DHCP > Server (Configure Global) page to enable the
DHCP Server.
CLI R
EFERENCES
◆
P
ARAMETERS
These parameters are displayed:
◆
DHCP Server – Enables or disables the DHCP server on this switch.
(Default: Disabled)
W
EB
I
NTERFACE
To enable the DHCP server:
1.
Click IP Service, DHCP, Server.
2.
Select Configure Global from the Step list.
3.
Mark the Enabled box.
4.
Click Apply.
Figure 364: Enabling the DHCP Server
S
ETTING
E
XCLUDED
A
DDRESSES
Use the IP Service > DHCP > Server (Configure Excluded Addresses – Add)
page to specify the IP addresses that should not be assigned to clients.
CLI R
EFERENCES
◆
"ip dhcp excluded-address" on page 1369
P
ARAMETERS
These parameters are displayed:
◆
Start IP Address – Specifies a single IP address or the first address in
a range that the DHCP server should not assign to DHCP clients.