LevelOne GTL-2691 - Manual (Page 718)

C HAPTER 21 | Multicast Routing
Configuring PIM for IPv4
– 718 –
D ISPLAYING N EIGHBOR
I NFORMATION
Use the Routing Protocol > PIM > Neighbor page to display all neighboring
PIM routers.
CLI R EFERENCES
◆ "show ip pim neighbor" on page 1562
P ARAMETERS
These parameters are displayed:
◆ Address – IP address of the next-hop router.
◆ VLAN – VLAN that is attached to this neighbor.
◆ Uptime – The duration this entry has been active.
◆ Expire – The time before this entry will be removed.
W EB I NTERFACE
To display neighboring PIM routers:
1. Click Routing Protocol, PIM, Neighbor.
Figure 461: Showing PIM Neighbors
C ONFIGURING G LOBAL
PIM-SM S ETTINGS
Use the Routing Protocol > PIM > SM (Configure Global) page to configure
the rate at which register messages are sent, the source of register
messages, and switchover to the Shortest Path Tree (SPT).
CLI R EFERENCES
◆ "IPv4 PIM Commands" on page 1553
P ARAMETERS
These parameters are displayed:
◆ Register Rate Limit – Configures the rate at which register messages
are sent by the Designated Router (DR) for each (source, group) entry.
(Range: 1-65535 packets per second: Default: disabled)
This parameter can be used to relieve the load on the designated router
(DR) and rendezvous point (RP). However, because register messages
exceeding the limit are dropped, some receivers may experience data
packet loss within the first few seconds in which register messages are
sent from bursty sources.