LevelOne GTL-2691 - Manual (Page 1246)

C HAPTER 42 | Multicast Filtering Commands
MVR for IPv6
– 1246 –
mvr6 associated-
profile
This command binds the MVR group addresses specified in a profile to an
MVR domain. Use the no form of this command to remove the binding.
S YNTAX
[no] mvr6 domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-20 characters)
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
MRV6 domains can be associated with more than one MVR6 profile. But
since MVR6 domains cannot share the group range, an MRV6 profile can
only be associated with one MVR6 domain.
E XAMPLE
The following an MVR group address profile to domain 1:
Console(config)#mvr6 domain 1 associated-profile rd
Console(config)#
mvr6 domain This command enables Multicast VLAN Registration (MVR) for a specific
domain. Use the no form of this command to disable MVR for a domain.
S YNTAX
[no] mvr6 domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
When MVR6 is enabled on a domain, any multicast data associated with an
MVR6 group is sent from all designated source ports, to all receiver ports
that have registered to receive data from that multicast group.