LevelOne GTL-2691 - Manual (Page 90)

C HAPTER 2 | Initial Switch Configuration
Basic Configuration
– 90 –
4. Type “username admin password 0 password,” for the Privileged Exec
level, where password is your new password. Press .
Username: admin
Password:
CLI session with the GTL-2691 is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#
S ETTING AN IP
A DDRESS
You must establish IP address information for the stack to obtain
management access through the network. This can be done in either of the
following ways:
◆ Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet
as the stack's master unit, you will also need to specify the default
gateway router.
◆ Dynamic — The switch can send IPv4 configuration requests to BOOTP
or DHCP address allocation servers on the network. An IPv6 link local
address for use in a local network can be dynamically generated as
described in "Obtaining an IPv6 Address" on page 94 .
The current software does not support DHCP for IPv6, so an IPv6 global
unicast address for use in a network containing more than one subnet
can only be manually configured as described in "Assigning an IPv6
Address" on page 91 .
M ANUAL C ONFIGURATION
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and
management stations that exist on another network segment. Valid IPv4
addresses consist of four decimal numbers, 0 to 255, separated by periods.
Anything outside this format will not be accepted by the CLI program.
N OTE :
An default IPv4 address for this switch is 192.168.1.1
A SSIGNING AN IP V 4 A DDRESS
Before you can assign an IP address to the switch, you must obtain the
following information from your network administrator:
◆ IP address for the switch
◆ Network mask for this network