LevelOne GTL-2691 - Manual (Page 1463)

C HAPTER 49 | IP Routing Commands
Routing Information Protocol (RIP)
– 1463 –
passive-interface This command stops RIP from sending routing updates on the specified
interface. Use the no form to disable this feature.
S YNTAX
[no] passive-interface vlan vlan-id
vlan-id - VLAN ID. (Range: 1-4093)
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Router Configuration
C OMMAND U SAGE
◆ If this command is used to stop sending routing updates on an
interface, the attached subnet will still continue to be advertised to
other interfaces, and updates from other routers on that interface will
continue to be received and processed.
◆ Use this command in conjunction with the neighbor command to
control the routing updates sent to specific neighbors.
E XAMPLE
Console(config-router)#passive-interface vlan1
Console(config-router)#
R ELATED C OMMANDS
neighbor (1461)
redistribute This command imports external routing information from other routing
domains (that is, directly connected routes, protocols, or static routes) into
the autonomous system. Use the no form to disable this feature.
S YNTAX
[no] redistribute (connected | ospf | static} [metric metric-value]
connected - Imports routes that are established automatically just
by enabling IP on an interface.
ospf - External routes will be imported from the Open Shortest Path
First (OSPF) protocol into this routing domain.
static - Static routes will be imported into this routing domain.
metric-value - Metric value assigned to all external routes for the
specified protocol. (Range: 1-16)
D EFAULT S ETTING
redistribution - none
metric-value - set by the default-metric command