LevelOne GTL-2691 - Manual (Page 565)

C HAPTER 15 | Multicast Filtering
Multicast VLAN Registration
– 565 –
◆ The MVR VLAN cannot be specified as the receiver VLAN for static
bindings.
P ARAMETERS
These parameters are displayed:
◆ Domain ID – An independent multicast domain. (Range: 1-5)
◆ Interface – Port or trunk identifier.
◆ VLAN – VLAN identifier. (Range: 1-4093)
◆ Group IP Address – Defines a multicast service sent to the selected
port. Multicast groups must be assigned from the MVR group range
configured on the Configure General page.
W EB I NTERFACE
To assign a static MVR group to an interface:
1.
Click Multicast, MVR.
2.
Select Configure Static Group Member from the Step list.
3.
Select Add from the Action list.
4.
Select an MVR domain.
5.
Select a VLAN and interface to receive the multicast stream, and then
enter the multicast group address.
6. Click Apply.
Figure 333: Assigning Static MVR Groups to a Port
To show the static MVR groups assigned to an interface:
1. Click Multicast, MVR.
2. Select Configure Static Group Member from the Step list.
3. Select Show from the Action list.