LevelOne GTL-2691 - Manual (Page 435)

C HAPTER 14 | Basic Administration Protocols
Simple Network Management Protocol
– 435 –
C ONFIGURING
SNMP V 3 G ROUPS
Use the Administration > SNMP (Configure Group) page to add an SNMPv3
group which can be used to set the access policy for its assigned users,
restricting them to specific read, write, and notify views. You can use the
pre-defined default groups or create new groups to map a set of SNMP
users to SNMP views.
CLI R EFERENCES
◆ "show snmp group" on page 840
P ARAMETERS
These parameters are displayed:
◆ Group Name – The name of the SNMP group to which the user is
assigned. (Range: 1-32 characters)
◆ Security Model – The user security model; SNMP v1, v2c or v3.
◆ Security Level – The following security levels are only used for the
groups assigned to the SNMP security model:
■
noAuthNoPriv – There is no authentication or encryption used in
SNMP communications. (This is the default security level.)
■
AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted.
■
AuthPriv – SNMP communications use both authentication and
encryption.
◆ Read View – The configured view for read access.
(Range: 1-64 characters)
◆ Write View – The configured view for write access.
(Range: 1-64 characters)
◆ Notify View – The configured view for notifications.
(Range: 1-64 characters)