LevelOne GTL-2691 - Manual (Page 1015)

C HAPTER 31 | Interface Commands
Cable Diagnostics
– 1015 –
Cable Short with accuracy 0 meters.
Pair A OK, length 1 meters
Pair B OK, length 2 meters
Pair C Short, length 1 meters
Pair D Short, length 2 meters
Last Update 0n 2010-04-23 07:59:26
Console#
test loop internal This command performs an internal loop back test on the specified port.
S YNTAX
test loop internal interface interface
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
When performing an internal loopback test, packets from the specified
interface are looped back into its internal PHY. Outgoing data is looped
back to the receiver without actually being transmitted. Internal loopback
makes it possible to check that an interface is working properly without
having to make any network connections.
E XAMPLE
Console#test loop internal interface ethernet 1/1
Internal loopback test: succeeded
Console#
show cable-
diagnostics dsp
This command shows the results of a cable diagnostics test.
S YNTAX
show cable-diagnostics dsp interface [interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
C OMMAND M ODE
Privileged Exec