Switchport mode, Switchport, Mode – LevelOne GTL-2691 User Manual
Page 1119
C
HAPTER
39
| VLAN Commands
Configuring VLAN Interfaces
– 1119 –
switchport mode
This command configures the VLAN membership mode for a port. Use the
no form to restore the default.
S
YNTAX
switchport mode {access | hybrid | trunk | private-vlan}
no switchport mode
access - Specifies an access VLAN interface. The port transmits and
receives untagged frames on a single VLAN only.
hybrid - Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
trunk - Specifies a port as an end-point for a VLAN trunk. A trunk is
a direct link between two switches, so the port transmits tagged
frames that identify the source VLAN. Note that frames belonging to
the port’s default VLAN (i.e., associated with the PVID) are also
transmitted as tagged frames.
private-vlan - For an explanation of this command see the
command.
D
EFAULT
S
ETTING
All ports are in hybrid mode with the PVID set to VLAN 1.
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
Access mode is mutually exclusive with VLAN trunking (see the
command). If VLAN trunking is enabled on an interface, then that
interface cannot be set to access mode, and vice versa.
E
XAMPLE
The following shows how to set the configuration mode to port 1, and then
set the switchport mode to hybrid:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
R
ELATED
C
OMMANDS