Switchport acceptable-frame- types, Switchport acceptable-frame-types, Switchport acceptable – LevelOne GTL-2691 User Manual
Page 1116: Frame-types
C
HAPTER
39
| VLAN Commands
Configuring VLAN Interfaces
– 1116 –
C
OMMAND
U
SAGE
◆
Creating a “normal” VLAN with the
command initializes it as a
Layer 2 interface. To change it to a Layer 3 interface, use the
command to enter interface configuration for the desired VLAN, enter
any Layer 3 configuration commands, and save the configuration
settings.
◆
To change a Layer 3 normal VLAN back to a Layer 2 VLAN, use the
no
command.
E
XAMPLE
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
R
ELATED
C
OMMANDS
switchport
acceptable-frame-
types
This command configures the acceptable frame types for a port. Use the
no form to restore the default.
S
YNTAX
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
all - The port accepts all frames, tagged or untagged.
tagged - The port only receives tagged frames.
D
EFAULT
S
ETTING
All frame types
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
When set to receive all frame types, any received frames that are untagged
are assigned to the default VLAN.