Table 75: https system support – LevelOne GTL-2691 User Manual
Page 886
C
HAPTER
28
| Authentication Commands
Web Server
– 886 –
C
OMMAND
U
SAGE
◆
Both HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure the HTTP and HTTPS servers to
use the same UDP port.
◆
If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port_number]
◆
When you start HTTPS, the connection is established in this way:
■
The client authenticates the server using the server’s digital
certificate.
■
The client and server negotiate a set of security protocols to use for
the connection.
■
The client and server generate session keys for encrypting and
decrypting data.
◆
The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer 5.0
or above, and Mozilla Firefox 2.0 or above.
The following web browsers and operating systems currently support
HTTPS:
◆
To specify a secure-site certificate, see “Replacing the Default Secure-
site Certificate” on page
. Also refer to the
tftp https-certificate
command.
E
XAMPLE
Console(config)#ip http secure-server
Console(config)#
R
ELATED
C
OMMANDS
copy tftp https-certificate
Table 75: HTTPS System Support
Web Browser
Operating System
Internet Explorer 5.0 or later Windows 98,Windows NT (with service pack 6a),
Windows 2000, XP, 7, 8
Mozilla Firefox 2.0 or later
Windows 2000, XP, 7, 8, and Linux