Snmp target host commands, Snmp-server enable traps – LevelOne GTL-2691 User Manual
Page 832
C
HAPTER
25
| SNMP Commands
SNMP Target Host Commands
– 832 –
SNMP Target Host Commands
snmp-server enable
traps
This command enables this device to send Simple Network Management
Protocol traps or informs (i.e., SNMP notifications). Use the no form to
disable SNMP notifications.
S
YNTAX
[no] snmp-server enable traps [authentication | link-up-down]
authentication - Keyword to issue authentication failure
notifications.
link-up-down - Keyword to issue link-up or link-down notifications.
D
EFAULT
S
ETTING
Issue authentication and link-up-down traps.
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to configure
this device to send SNMP notifications, you must enter at least one
snmp-server enable traps command. If you enter the command with
no keywords, both authentication and link-up-down notifications are
enabled. If you enter the command with a keyword, only the
notification type related to that keyword is enabled.
◆
The snmp-server enable traps command is used in conjunction with
the
command. Use the
command
to specify which host or hosts receive SNMP notifications. In order to
send notifications, you must configure at least one
command.
◆
The authentication, link-up, and link-down traps are legacy
notifications, and therefore when used for SNMP Version 3 hosts, they
must be enabled in conjunction with the corresponding entries in the
Notify View assigned by the
command.
E
XAMPLE
Console(config)#snmp-server enable traps link-up-down
Console(config)#
R
ELATED
C
OMMANDS