LevelOne GTL-2691 - Manual (Page 1580)

C HAPTER 50 | Multicast Routing Commands
PIM Multicast Routing
– 1580 –
E XAMPLE
Console(config-if)#ipv6 pim hello-interval 60
Console(config-if)#
ipv6 pim join-prune-
holdtime
This command configures the hold time for the prune state. Use the no
form to restore the default value.
S YNTAX
ipv6 pim join-prune-holdtime seconds
no ipv6 pim join-prune-holdtime
seconds - The hold time for the prune state. (Range: 0-65535)
D EFAULT S ETTING
210 seconds
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
The multicast interface that first receives a multicast stream from a
particular source forwards this traffic to all other PIM interfaces on the
router. If there are no requesting groups on that interface, the leaf node
sends a prune message upstream and enters a prune state for this
multicast stream. The prune state is maintained until the join-prune-
holdtime timer expires or a graft message is received for the forwarding
entry.
E XAMPLE
Console(config-if)#ipv6 pim join-prune-holdtime 60
Console(config-if)#
ipv6 pim lan-prune-
delay
This command causes this device to inform downstream routers of how
long it will wait before pruning a flow after receiving a prune request. Use
the no form to disable this feature.
S YNTAX
[no] ipv6 pim lan-prune-delay
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (VLAN)