LevelOne GTL-2691 - Manual (Page 753)

C HAPTER 22 | Using the Command Line Interface
Entering Commands
– 753 –
display the “Console#” command prompt. You can also enter Privileged
Exec mode from within Normal Exec mode, by entering the enable
command, followed by the privileged level password “super.”
To enter Privileged Exec mode, enter the following user names and
passwords:
Username: admin
Password: [admin login password]
CLI session with the GTL-2691 is opened.
To end the CLI session, enter [Exit].
Console#
Username: guest
Password: [guest login password]
CLI session with the GTL-2691 is opened.
To end the CLI session, enter [Exit].
Console>enable
Password: [privileged level password]
Console#
C ONFIGURATION
C OMMANDS
Configuration commands are privileged level commands used to modify
switch settings. These commands modify the running configuration only
and are not saved when the switch is rebooted. To store the running
configuration in non-volatile storage, use the copy running-config
startup-config command.
The configuration commands are organized into different modes:
◆ Global Configuration - These commands modify the system level
configuration, and include commands such as hostname and snmp-
server community.
◆ Access Control List Configuration - These commands are used for
packet filtering.
◆ Class Map Configuration - Creates a DiffServ class map for a specified
traffic type.
◆ DHCP Configuration - These commands are used to configure the DHCP
server.
◆ IGMP Profile - Sets a profile group and enters IGMP filter profile
configuration mode.
◆ Interface Configuration - These commands modify the port
configuration such as speed-duplex and negotiation.