LevelOne GTL-2691 - Manual (Page 908)

C HAPTER 28 | Authentication Commands
802.1X Port Authentication
– 908 –
Display Information Commands
show dot1x This command shows general port authentication related settings on the
switch or a specific interface.
S YNTAX
show dot1x [statistics] [interface interface]
statistics - Displays dot1x status for each port.
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
This command displays the following information:
◆ Global 802.1X Parameters – Shows whether or not 802.1X port
authentication is globally enabled on the switch ( page 901 ).
◆ Authenticator Parameters – Shows whether or not EAPOL pass-through
is enabled (
page 900 ).
◆ 802.1X Port Summary – Displays the port access control parameters
for each interface that has enabled 802.1X, including the following
items:
■
Type – Administrative state for port access control (Enabled,
Authenticator, or Supplicant).
■
Operation Mode–Allows single or multiple hosts ( page 903 ).
■
Control Mode– Dot1x port control mode ( page 904 ).
■
Authorized– Authorization status (yes or n/a - not authorized).
◆ 802.1X Port Details – Displays the port access control parameters for
each interface, including the following items:
■
Reauthentication – Periodic re-authentication ( page 904 ).
■
Reauth Period – Time after which a connected client must be re-
authenticated ( page 905 ).
■
Quiet Period – Time a port waits after Max Request Count is
exceeded before attempting to acquire a new client ( page 905 ).
■
TX Period – Time a port waits during authentication session before
re-transmitting EAP packet ( page 906 ).
■
Supplicant Timeout – Supplicant timeout.
■
Server Timeout – Server timeout. A RADIUS server must be set
before the correct operational value of 10 seconds will be displayed
in this field.