Logging on, Logging trap – LevelOne GTL-2691 User Manual
Page 801
C
HAPTER
24
| System Management Commands
Event Logging
– 801 –
E
XAMPLE
Console(config)#logging host 10.1.0.3
Console(config)#
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
S
YNTAX
[no] logging on
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
The logging process controls error messages saved to switch memory or
sent to remote syslog servers. You can use the
command to
control the type of error messages that are stored in memory. You can use
the
command to control the type of error messages that are
sent to specified syslog servers.
E
XAMPLE
Console(config)#logging on
Console(config)#
R
ELATED
C
OMMANDS
logging trap
This command enables the logging of system messages to a remote server,
or limits the syslog messages saved to a remote server based on severity.
Use this command without a specified level to enable remote logging. Use
the no form to disable remote logging.
S
YNTAX
logging trap [level level]
no logging trap [level]
level - One of the syslog severity levels listed in the table on
. Messages sent include the selected level through level 0.