LevelOne GTL-2691 User Manual
Page 1576
C
HAPTER
50
| Multicast Routing Commands
PIM Multicast Routing
– 1576 –
Sets the interval between sending PIM hello messages IC
Configures the hold time for the prune state
IC
Informs downstream routers of the delay before it
prunes a flow after receiving a prune request
IC
Specifies the time it takes a downstream router to
respond to a lan-prune-delay message
IC
Configures the propagation delay required for a LAN
prune delay message to reach downstream routers
IC
Configures the trigger hello delay
IC
Displays information about interfaces configured for
PIM
NE, PE
Displays information about PIM neighbors
NE, PE
PIM-DM Commands
Configures the time to wait for a Graft
acknowledgement before resending a Graft message
IC
Configures the maximum number of times to resend a
Graft message if it has not been acknowledged
IC
Sets the interval between PIM-DM state refresh control
messages
IC
PIM-SM Commands
Configures the switch as a Bootstrap Router (BSR)
candidate
GC
Configures the rate at which register messages are
sent by the Designated Router (DR)
GC
Configure the IP source address of a register message
to an address other than the outgoing interface
address of the designated router (DR) leading toward
the rendezvous point (RP)
GC
Sets a static address for the rendezvous point
GC
Configures the switch rendezvous point (RP) candidate GC
Prevents the last-hop PIM router from switching to
Shortest Path Source Tree (SPT) mode
GC
Sets the priority value for a DR candidate
IC
Sets the join/prune timer
IC
Clears RP entries learned through the BSR
PE
Displays information about the BSR
PE
Displays active RPs and associated multicast routing
entries
PE
Displays the RP used for the specified multicast group PE
Table 234: PIM-DM and PIM-SM Multicast Routing Commands (Continued)
Command
Function
Mode