LevelOne GTL-2691 - Manual (Page 1536)

C HAPTER 49 | IP Routing Commands
Open Shortest Path First (OSPFv3)
– 1536 –
receive them. To avoid this problem, use the transmit delay to force the
router to wait a specified interval between transmissions.
E XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 ospf transmit-delay 6
Console(config-if)#
passive-interface This command suppresses OSPF routing traffic on the specified interface.
Use the no form to allow routing traffic to be sent and received on the
specified interface.
S YNTAX
[no] passive-interface vlan vlan-id [ipv6-address]
vlan-id - VLAN ID. (Range: 1-4093)
ipv6-address - A full IPv6 address including the network prefix and
host address bits.
C OMMAND M ODE
Router Configuration
D EFAULT S ETTING
None
C OMMAND U SAGE
You can configure an OSPF interface as passive to prevent OSPF routing
traffic from exiting or entering that interface. No OSPF adjacency can be
formed if one of the interfaces involved is set to passive mode. The
specified interface will appear as a stub in the OSPF domain. Also, if you
configure an OSPF interface as passive where an adjacency already exists,
the adjacency will drop almost immediately.
E XAMPLE
Console(config-router)#passive-interface vlan 1 73::9
Console(config-router)#