Configuring the pppoe intermediate agent, Configuring pppoe ia global settings, Pppoe intermediate agent – LevelOne GTL-2691 User Manual
Page 615
C
HAPTER
17
| IP Services
Configuring the PPPoE Intermediate Agent
– 615 –
3.
Enter the address of the remote server or subnet where UDP request
packets are to be forwarded.
4.
Click Apply.
Figure 374: Specifying the Target Server or Subnet for UDP Requests
To show the target server or subnet for UDP requests:
1.
Click IP Service, UDP Helper, Address.
2.
Select Show from the Action list.
Figure 375: Showing the Target Server or Subnet for UDP Requests
C
ONFIGURING
THE
PPP
O
E I
NTERMEDIATE
A
GENT
This section describes how to configure the PPPoE Intermediate Agent
(PPPoE IA) relay parameters required for passing authentication messages
between a client and broadband remote access servers.
C
ONFIGURING
PPP
O
E
IA G
LOBAL
S
ETTINGS
Use the IP Service > PPPoE Intermediate Agent (Configure Global) page to
enable the PPPoE IA on the switch, set the access node identifier, and set
the generic error message.
CLI R
EFERENCES
◆
"pppoe intermediate-agent" on page 913
◆
"pppoe intermediate-agent format-type" on page 914
◆