Ipv6 ospf dead- interval, Ipv6 ospf dead-interval – LevelOne GTL-2691 User Manual
Page 1532
C
HAPTER
49
| IP Routing Commands
Open Shortest Path First (OSPFv3)
– 1532 –
ipv6 ospf dead-
interval
This command sets the interval at which hello packets are not seen before
neighbors declare the router down. Use the no form to restore the default
value.
S
YNTAX
ipv6 ospf dead-interval seconds [instance-id instance-id]
no ipv6 ospf dead-interval [instance-id instance-id]
seconds - The maximum time that neighbor routers can wait for a
hello packet before declaring the transmitting router down. This
interval must be set to the same value for all routers on the
network. (Range: 1-65535)
instance-id - Identifies a specific OSPFv3 routing process on the
link-local network segment attached to this interface.
(Range: 0-255)
C
OMMAND
M
ODE
Interface Configuration (VLAN)
D
EFAULT
S
ETTING
40 seconds, or four times the interval specified by the
command.
C
OMMAND
U
SAGE
The dead-interval is advertised in the router's hello packets. It must be a
multiple of the hello-interval and be the same for all routers on a specific
network.
E
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 ospf dead-interval 50
Console(config-if)#
R
ELATED
C
OMMANDS