LevelOne GTL-2691 - Manual (Page 1050)

C HAPTER 35 | Automatic Traffic Control Commands
SNMP Trap Commands
– 1050 –
SNMP Trap Commands
snmp-server enable
port-traps atc
broadcast-alarm-
clear
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no
form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc broadcast-alarm-clear
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-clear
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control action (1046)
auto-traffic-control alarm-clear-threshold (1047)
snmp-server enable
port-traps atc
broadcast-alarm-fire
This command sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control. Use the no form to disable this trap.
S YNTAX
[no] snmp-server enable port-traps atc broadcast-alarm-fire
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-fire
Console(config-if)#
R ELATED C OMMANDS
auto-traffic-control alarm-fire-threshold (1048)