LevelOne GTL-2691 - Manual (Page 207)

C HAPTER 6 | VLAN Configuration
IEEE 802.1Q VLANs
– 207 –
Figure 68: Configuring Static VLAN Members by Interface Range
C ONFIGURING
D YNAMIC VLAN
R EGISTRATION
Use the VLAN > Dynamic page to enable GVRP globally on the switch, or to
enable GVRP and adjust the protocol timers per interface.
CLI R EFERENCES
◆ "GVRP and Bridge Extension Commands" on page 1108
◆ "Configuring VLAN Interfaces" on page 1115
P ARAMETERS
These parameters are displayed:
Configure General
◆ GVRP Status – GVRP defines a way for switches to exchange VLAN
information in order to register VLAN members on ports across the
network. VLANs are dynamically configured based on join messages
issued by host devices and propagated throughout the network. GVRP
must be enabled to permit automatic VLAN registration, and to support
VLANs which extend beyond the local switch. (Default: Disabled)
Configure Interface
◆ Interface – Displays a list of ports or trunks.
◆ Port – Port Identifier. (Range: 1-26)
◆ Trunk – Trunk Identifier. (Range: 1-32)
◆ GVRP Status – Enables/disables GVRP for the interface. GVRP must be
globally enabled for the switch before this setting can take effect (using
the Configure General page). When disabled, any GVRP packets
received on this port will be discarded and no GVRP registrations will be
propagated from other ports. (Default: Disabled)
GVRP cannot be enabled for ports set to Access mode (see
"Adding
Static Members to VLANs" on page 202 ).
◆ GVRP Timers – Timer settings must follow this rule:
3 x (join timer) < leave timer < leaveAll timer