beautypg.com

Voip traffic configuration, Overview, Configuring voip traffic – LevelOne GTL-2691 User Manual

Page 303: 12 v, Ip t, Raffic, Onfiguration, Overview 303 configuring voip traffic

background image

– 303 –

12

V

O

IP T

RAFFIC

C

ONFIGURATION

This chapter covers the following topics:

Global Settings

– Enables VOIP globally, sets the Voice VLAN, and the

aging time for attached ports.

Telephony OUI List

– Configures the list of phones to be treated as VOIP

devices based on the specified Organization Unit Identifier (OUI).

Port Settings

Configures the way in which a port is added to the Voice

VLAN, the filtering of non-VoIP packets, the method of detecting VoIP

traffic, and the priority assigned to voice traffic.

O

VERVIEW

When IP telephony is deployed in an enterprise network, it is

recommended to isolate the Voice over IP (VoIP) network traffic from other

data traffic. Traffic isolation can provide higher voice quality by preventing

excessive packet delays, packet loss, and jitter. This is best achieved by

assigning all VoIP traffic to a single Voice VLAN.

The use of a Voice VLAN has several advantages. It provides security by

isolating the VoIP traffic from other data traffic. End-to-end QoS policies

and high priority can be applied to VoIP VLAN traffic across the network,

guaranteeing the bandwidth it needs. VLAN isolation also protects against

disruptive broadcast and multicast traffic that can seriously affect voice

quality.

The switch allows you to specify a Voice VLAN for the network and set a

CoS priority for the VoIP traffic. The VoIP traffic can be detected on switch

ports by using the source MAC address of packets, or by using LLDP (IEEE

802.1AB) to discover connected VoIP devices. When VoIP traffic is detected

on a configured port, the switch automatically assigns the port as a tagged

member the Voice VLAN. Alternatively, switch ports can be manually

configured.

C

ONFIGURING

V

O

IP T

RAFFIC

Use the Traffic > VoIP (Configure Global) page to configure the switch for

VoIP traffic. First enable automatic detection of VoIP devices attached to

the switch ports, then set the Voice VLAN ID for the network. The Voice

VLAN aging time can also be set to remove a port from the Voice VLAN

when VoIP traffic is no longer received on the port.