LevelOne GTL-2691 - Manual (Page 1502)

C HAPTER 49 | IP Routing Commands
Open Shortest Path First (OSPFv2)
– 1502 –
E XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ip ospf transmit-delay 6
Console(config-if)#
passive-interface This command suppresses OSPF routing traffic on the specified interface.
Use the no form to allow routing traffic to be sent and received on the
specified interface.
S YNTAX
[no] passive-interface vlan vlan-id [ip-address]
vlan-id - VLAN ID. (Range: 1-4093)
ip-address - An IPv4 address configured on this interface.
C OMMAND M ODE
Router Configuration
D EFAULT S ETTING
None
C OMMAND U SAGE
You can configure an OSPF interface as passive to prevent OSPF routing
traffic from exiting or entering that interface. No OSPF adjacency can be
formed if one of the interfaces involved is set to passive mode. The
specified interface will appear as a stub in the OSPF domain. Also, if you
configure an OSPF interface as passive where an adjacency already exists,
the adjacency will drop almost immediately.
E XAMPLE
Console(config-router)#passive-interface vlan 1
Console(config-router)#
Display Information
show ip ospf This command shows basic information about the routing configuration.
S YNTAX
show ip ospf [process-id]
process-id - The ID of the router process for which information will
be displayed. (Range: 1-65535)
C OMMAND M ODE
Privileged Exec