Ipv6 pim propagation-delay, Ipv6 pim propagation, Delay – LevelOne GTL-2691 User Manual
Page 1582
C
HAPTER
50
| Multicast Routing Commands
PIM Multicast Routing
– 1582 –
Join message back to the upstream router to ensure that the flow is not
terminated.
E
XAMPLE
Console(config-if)#ipv6 pim override-interval 3500
Console(config-if)#
R
ELATED
C
OMMANDS
ipv6 pim propagation-delay (1582)
ipv6 pim lan-prune-delay (1580)
ipv6 pim
propagation-delay
This command configures the propagation delay required for a LAN prune
delay message to reach downstream routers. Use the no form to restore
the default setting.
ipv6 pim propagation-delay milliseconds
no ipv6 pim propagation-delay
milliseconds - The time required for a lan-prune-delay message to
reach downstream routers attached to the same VLAN interface.
(Range: 100-5000 milliseconds)
D
EFAULT
S
ETTING
500 milliseconds
C
OMMAND
M
ODE
Interface Configuration (VLAN)
C
OMMAND
U
SAGE
The override interval configured by the
command and the propagation delay configured by this command are used
to calculate the LAN prune delay. If a downstream router has group
members which want to continue receiving the flow referenced in a LAN
prune delay message, then the propagation delay represents the time
required for the lan-prune-delay message to be propagated down from the
upstream router to all downstream routers attached to the same VLAN
interface.
E
XAMPLE
Console(config-if)#ipv6 pim propagation-delay 600
Console(config-if)#
R
ELATED
C
OMMANDS