LevelOne GTL-2691 - Manual (Page 1551)

C HAPTER 50 | Multicast Routing Commands
Static Multicast Routing
– 1551 –
This example lists all entries in the multicast table in summary form:
Console#show ipv6 mroute summary
IP Multicast Forwarding is disabled
IP Multicast Routing Table (Summary)
Flags: F - Forwarding, P - Pruned, D - PIM-DM, S – PIM-SM, V – DVMRP,
M - MLD
Group Source Interface Flag
------------------------------ ------------------------------ ---------- ----
FF02::0101 FE80::0101 VLAN 4096 DF
Total Entry is 1
Console#
S TATIC M ULTICAST R OUTING
This section describes commands used to configure static multicast routes
on the switch.
ip igmp snooping
vlan mrouter
This command statically configures a multicast router port. Use the no
form to remove the configuration.
S YNTAX
ip igmp snooping vlan vlan-id mrouter interface
no ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4093)
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26/50)
port-channel channel-id (Range: 1-32)
D EFAULT S ETTING
No static multicast router ports are configured.
C OMMAND M ODE
Global Configuration
Table 227: Static Multicast Routing Commands
Command Function Mode
ip igmp snooping vlan
mrouter
Adds a multicast router port GC
show ip igmp snooping
mrouter
Shows multicast router ports PE