LevelOne GTL-2691 - Manual (Page 859)

C HAPTER 27 | Flow Sampling Commands
– 859 –
sflow sample This command configures the packet sampling rate. Use the no form to
restore the default rate.
S YNTAX
sflow sample rate
no sflow sample
rate - The packet sampling rate, or the number of packets out of
which one sample will be taken. (Range: 256-16777215 packets)
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
This example sets the sample rate to 1 out of every 100 packets.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow sample 100
Console(config-if)#
sflow source This command enables sFlow on the source ports to be monitored. Use the
no form to disable sFlow on the specified ports.
S YNTAX
[no] sflow source
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
E XAMPLE
This example enables flow control on ports 9 through 16.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow source
Console(config-if)#