Ipv6 commands, Ipv6 route – LevelOne GTL-2691 User Manual
Page 1454
C
HAPTER
49
| IP Routing Commands
Global Routing Configuration
– 1454 –
IPv6 Commands
ipv6 route
This command configures static IPv6 routes. Use the no form to remove
static routes.
S
YNTAX
[no] ipv6 route destination-ipv6-address/prefix-length
{gateway-address [distance] |
link-local-address%zone-id [distance] |
tunnel interface-number}
destination-ipv6-address – The IPv6 address of a destination
network, subnetwork, or host. This must be a full IPv6 address
including the network prefix and host address bits.
prefix-length - A decimal value indicating how many contiguous bits
(from the left) of the address comprise the prefix (i.e., the network
portion of the address).
gateway-address – IP address of the next hop router used for this
route.
link-local-address%zone-id – a link-local address, including a
zone-id indicating the VLAN identifier after the % delimiter.
distance – An administrative distance indicating that this route can
be overridden by dynamic routing information if the distance of the
dynamic route is less than that configured for the static route. Note
that the default administrative distances used by the dynamic
unicast routing protocols is 110 for OSPF and 120 for RIP.
(Range: 1-255, Default: 1)
interface-number – The number of the outgoing tunnel interface
used to reach the destination IPv6 address. (Range: 1-16)
See the
command for more information.
D
EFAULT
S
ETTING
No static routes are configured.
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
Up to 1K static routes can be configured.
◆
Up to eight equal-cost multipaths (ECMP) can be configured for static
routing using the
command.
◆
If an administrative distance is defined for a static route, and the same
destination can be reached through a dynamic route at a lower
administration distance, then the dynamic route will be used.
◆
The default distance of 1 will take precedence over any other type of
route, except for local routes.