LevelOne GTL-2691 - Manual (Page 633)

C HAPTER 18 | General IP Routing
Configuring Static Routes
– 633 –
D ISPLAYING ARP
S TATISTICS
Use the IP > ARP (Show Information) page to display statistics for ARP
messages crossing all interfaces on this router.
CLI R EFERENCES
◆ "show ip traffic" on page 1452
P ARAMETERS
These parameters are displayed:
W EB I NTERFACE
To display ARP statistics:
1. Click IP, ARP.
2. Select Show Information from the Step List.
3. Click Statistics.
Figure 388: Displaying ARP Statistics
C
ONFIGURING
S
TATIC
R
OUTES
This router can dynamically configure routes to other network segments
using dynamic routing protocols (i.e., RIP or OSPF). However, you can also
manually enter static routes in the routing table using the IP > Routing >
Static Routes (Add) page. Static routes may be required to access network
segments where dynamic routing is not supported, or can be set to force
the use of a specific route to a subnet, rather than using dynamic routing.
Static routes do not automatically change in response to changes in
Table 36: ARP Statistics
Parameter Description
Received Request Number of ARP Request packets received by the router.
Received Reply Number of ARP Reply packets received by the router.
Sent Request Number of ARP Request packets sent by the router.
Sent Reply Number of ARP Reply packets sent by the router.