Show ipv6 route – LevelOne GTL-2691 User Manual
Page 1455
C
HAPTER
49
| IP Routing Commands
Global Routing Configuration
– 1455 –
◆
If both static and dynamic paths have the same lowest cost, the first
route stored in the routing table, either statically configured or
dynamically learned via a routing protocol, will be used.
◆
Static routes are included in RIP and OSPF updates periodically sent by
the router if this feature is enabled by the OSPFv3
).
E
XAMPLE
This example forwards all traffic for subnet 2001::/64 to the next hop
router 2001:DB8:2222:7272::254, using the default metric of 1.
Console(config)#ipv6 route 2001::/64 2001:DB8:2222:7272::254
Console(config)#
R
ELATED
C
OMMANDS
show ip route summary (1450)
show ipv6 route
This command displays information in the Forwarding Information Base
(FIB).
S
YNTAX
show ipv6 route [ipv6-address[/prefix-length] | database |
interface [tunnel tunnel-number | vlan vlan-id] | local | ospf |
rip | static]
ipv6-address - A full IPv6 address including the network prefix and
host address bits.
prefix-length - A decimal value indicating how many contiguous bits
(from the left) of the address comprise the prefix (i.e., the network
portion of the address).
database – All known routes, including inactive routes.
interface – Displays all routes that be accessed through this
interface.
local – Displays all entries for destinations attached directly to this
router.
ospf – Displays external routes imported from the Open Shortest
Path First (OSPF) protocol into this routing domain.
rip – Displays all entries learned through the Routing Information
Protocol (RIP).
static – Displays all static entries.
tunnel-number - Tunnel interface identifier. (Range: 1-16)
vlan-id - VLAN ID. (Range: 1-4093)