LevelOne GTL-2691 - Manual (Page 1436)

C HAPTER 48 | IP Interface Commands
IPv6 Interface
– 1436 –
ipv6 nd ra
router-preference
This command configures the default router preference for the router on an
interface. Use the no form to restore the default setting.
S YNTAX
ipv6 nd ra router-preference {high | medium | low}
no ipv6 nd ra router-preference
high - Preference for the router is high.
medium - Preference for the router is medium.
low - Preference for the router is low.
C OMMAND M ODE
Interface Configuration (VLAN)
D EFAULT S ETTING
medium
C OMMAND U SAGE
Default router preference may be used to prioritize routers which provide
equivalent, but not equal-cost, routing, and policy dictates that hosts
should prefer one of the routers.
E XAMPLE
The following sets the default router preference to high:
Console(config)#interface vlan 1
Console(config)#ipv6 nd ra router-preference high
Console(config)#
ipv6 nd ra suppress This command suppresses router advertisement transmissions on an
interface. Use the no form to re-enable router advertisements.
S YNTAX
[no] ipv6 nd ra suppress
C OMMAND M ODE
Interface Configuration (VLAN, IPv6/v4 Tunnel)
D EFAULT S ETTING
Not suppressed
C OMMAND U SAGE
This command suppresses periodic unsolicited router advertisements. It
does not suppress advertisements sent in response to a router solicitation.