Mac access-group – LevelOne GTL-2691 User Manual
Page 989
C
HAPTER
30
| Access Control Lists
MAC ACLs
– 989 –
C
OMMAND
M
ODE
MAC ACL
C
OMMAND
U
SAGE
◆
New rules are added to the end of the list.
◆
The ethertype option can only be used to filter Ethernet II formatted
packets.
◆
A detailed listing of Ethernet protocol types can be found in RFC 1060.
A few of the more common types include the following:
■
0800 - IP
■
0806 - ARP
■
8137 - IPX
E
XAMPLE
This rule permits packets from any source MAC address to the destination
address 00-e0-29-94-34-de where the Ethernet type is 0800.
Console(config-mac-acl)#permit any host 00-e0-29-94-34-de ethertype 0800
Console(config-mac-acl)#
R
ELATED
C
OMMANDS
mac access-group
This command binds a MAC ACL to a port. Use the no form to remove the
port.
S
YNTAX
mac access-group acl-name in [time-range time-range-name]
acl-name – Name of the ACL. (Maximum length: 16 characters)
in – Indicates that this list applies to ingress packets.
time-range-name - Name of the time range.
(Range: 1-30 characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆
Only one ACL can be bound to a port.
◆
If an ACL is already bound to a port and you bind a different ACL to it,
the switch will replace the old binding with the new one.