Timers spf – LevelOne GTL-2691 User Manual
Page 1521
C
HAPTER
49
| IP Routing Commands
Open Shortest Path First (OSPFv3)
– 1521 –
C
OMMAND
U
SAGE
◆
This command sets the router ID for the OSPF process specified in the
command.
◆
The router ID must be unique for every router in the autonomous
system. (Note that the router ID can also be set to 255.255.255.255).
◆
If this router already has registered neighbors, the new router ID will
be used when the router is rebooted, or manually restarted by entering
the
followed by the
command.
◆
If the priority values of the routers bidding to be the designated router
or backup designated router for an area are equal, the router with the
highest ID is elected.
◆
The current routing process will not be enabled until a Router ID is
configured with this command.
E
XAMPLE
Console(config-router)#router-id 10.1.1.1
Console(config-router)#
R
ELATED
C
OMMANDS
timers spf
This command configures the delay after receiving a topology change and
starting the shortest path first (SPF) calculation, and the hold time
between making two consecutive SPF calculations. Use the no form to
restore the default values.
S
YNTAX
timers spf spf-delay spf-holdtime
no timers spf
spf-delay - The delay after receiving a topology change notification
and starting the SPF calculation. (Range: 0-2147483647 seconds)
spf-holdtime - The minimum time between two consecutive SPF
calculations. (Range: 0-2147483647 seconds)
C
OMMAND
M
ODE
Router Configuration
D
EFAULT
S
ETTING
SPF delay: 5 seconds
SPF holdtime: 10 seconds
C
OMMAND
U
SAGE
◆
Setting the SPF holdtime to 0 means that there is no delay between
consecutive calculations.