LevelOne GTL-2691 - Manual (Page 1149)

C HAPTER 39 | VLAN Commands
Configuring Voice VLANs
– 1149 –
voice vlan aging This command sets the Voice VLAN ID time out. Use the no form to restore
the default.
S YNTAX
voice vlan aging minutes
no voice vlan
minutes - Specifies the port Voice VLAN membership time out.
(Range: 5-43200 minutes)
D EFAULT S ETTING
1440 minutes
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
The Voice VLAN aging time is the time after which a port is removed from
the Voice VLAN when VoIP traffic is no longer received on the port.
The Remaining Age starts to count down when the OUI’s MAC address
expires from the MAC address table. Therefore, the MAC address aging
time should be added to the overall aging time. For example, if you
configure the MAC address table aging time to 30 seconds, and the voice
VLAN aging time to 5 minutes, then after 5.5 minutes, a port will be
removed from voice VLAN when VoIP traffic is no longer received on the
port. Alternatively, if you clear the MAC address table manually, then the
switch will also start counting down the Remaining Age.
E XAMPLE
The following example configures the Voice VLAN aging time as 3000
minutes.
Console(config)#voice vlan aging 3000
Console(config)#
voice vlan mac-
address
This command specifies MAC address ranges to add to the OUI Telephony
list. Use the no form to remove an entry from the list.
S YNTAX
voice vlan mac-address mac-address mask mask-address
[description description]
no voice vlan mac-address mac-address mask mask-address
mac-address - Defines a MAC address OUI that identifies VoIP
devices in the network. (For example, 01-23-45-00-00-00)
mask-address - Identifies a range of MAC addresses.
(Range: 80-00-00-00-00-00 to FF-FF-FF-FF-FF-FF)