LevelOne GTL-2691 - Manual (Page 1325)

C HAPTER 44 | CFM Commands
Defining CFM Structures
– 1325 –
show ethernet cfm
maintenance-points
local
This command displays the maintenance points configured on this device.
S YNTAX
show ethernet cfm maintenance-points local
{mep [domain domain-name | interface interface |
level level-id] | mip [domain domain-name | level level-id]}
mep – Displays only local maintenance end points.
mip – Displays only local maintenance intermediate points.
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
interface – Displays CFM status for the specified interface.
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-8)
level-id – Maintenance level for this domain. (Range: 0-7)
D EFAULT S ETTING
None
C OMMAND M ODE
Privileged Exec
C OMMAND U SAGE
◆ Use the mep keyword with this command to display the MEPs
configured on this device as DSAPs through the ethernet cfm mep
command.
◆ Using the mip keyword with this command to display the MIPs
generated on this device by the CFM protocol when the mip-creation
method is set to either “default” or “explicit” by the ethernet cfm
domain command or the ma index name command.
E XAMPLE
This example shows all MEPs configured on this device for maintenance
domain rd.
Console#show ethernet cfm maintenance-points local mep
MPID MD Name Level Direct VLAN Port CC Status MAC Address
---- ---------------- ----- ------ ---- -------- --------- -----------------
1 rd 0 UP 1 Eth 1/ 1 Enabled 00-12-CF-3A-A8-C0
Console#