Enable, Enable 761 – LevelOne GTL-2691 User Manual
Page 761
C
HAPTER
23
| General Commands
– 761 –
C
OMMAND
U
SAGE
◆
This command resets the entire system.
◆
Any combination of reload options may be specified. If the same option
is re-specified, the previous setting will be overwritten.
◆
When the system is restarted, it will always run the Power-On Self-Test.
It will also retain all configuration information stored in non-volatile
memory by the
running-config startup-config
command (See
E
XAMPLE
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2007 ---
***
Are you sure to reboot the system at the specified time?
enable
This command activates Privileged Exec mode. In privileged mode,
additional commands are available, and certain commands display
"Understanding Command Modes" on
S
YNTAX
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
D
EFAULT
S
ETTING
Level 15
C
OMMAND
M
ODE
Normal Exec
C
OMMAND
U
SAGE
◆
“super” is the default password required to change the command mode
from Normal Exec to Privileged Exec. (To set this password, see the
command.)
◆
The “#” character is appended to the end of the prompt to indicate that
the system is in privileged access mode.