Configuring global settings for multicast routing, Enabling multicast routing globally, Figure 455: enabling multicast routing – LevelOne GTL-2691 User Manual
Page 708: Configuring global, Enabling, Configuring global settings for
C
HAPTER
21
| Multicast Routing
Configuring Global Settings for Multicast Routing
– 708 –
data transmission delays. The switch can also be configured to use SPT
only for specific multicast groups, or to disable the change over to SPT for
specific groups.
C
ONFIGURING
G
LOBAL
S
ETTINGS
FOR
M
ULTICAST
R
OUTING
To use multicast routing on this router, first globally enable multicast
routing as described in this section, then specify the interfaces that will
employ multicast routing protocols (PIM-DM or PIM-SM for IPv4 on
, or PIM-DM for IPv6 on
). Note that only one IPv4
multicast routing protocol (PIM-DM or PIM-SM) can be enabled on any
given interface, but both PIMv4 and PIMv6 can be enabled on the same
interface.
E
NABLING
M
ULTICAST
R
OUTING
G
LOBALLY
Use the Multicast > Multicast Routing > General page to enable IP
multicast routing globally on the switch.
CLI R
EFERENCES
◆
"ip multicast-routing" on page 1545
P
ARAMETERS
These parameters are displayed:
◆
Multicast Forwarding Status – Enables IP multicast routing.
(Default: Disabled)
W
EB
I
NTERFACE
To enable multicast routing:
1.
Click Multicast, Multicast Routing, General.
2.
Enable Multicast Forwarding Status.
3.
Click Apply.
Figure 455: Enabling Multicast Routing