LevelOne GTL-2691 - Manual (Page 111)

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 111 –
Protocol
Configure Protocol
Add Creates a protocol group, specifying supported protocols 224
Show Shows configured protocol groups 224
Configure Interface
Add Maps a protocol group to a VLAN 226
Show Shows the protocol groups mapped to each VLAN 226
IP Subnet
Add Maps IP subnet traffic to a VLAN 228
Show Shows IP subnet to VLAN mapping 228
MAC-Based
Add Maps traffic with specified source MAC address to a VLAN 230
Show Shows source MAC address to VLAN mapping 230
MAC Address
Learning Status Enables MAC address learning on selected interfaces 233
Static
Add Configures static entries in the address table 235
Show Displays static entries in the address table 235
Dynamic
Configure Aging Sets timeout for dynamically learned entries 236
Show Dynamic MAC Displays dynamic entries in the address table 237
Clear Dynamic MAC Removes any learned entries from the forwarding database and
clears the transmit and receive counts for any static or system
configured entries
238
Spanning Tree
Loopback Detection Configures Loopback Detection parameters 243
STA Spanning Tree Algorithm
Configure Global
Configure Configures global bridge settings for STP, RSTP and MSTP 245
Show Information Displays STA values used for the bridge 250
Configure Interface
Configure Configures interface settings for STA 251
Show Informaton Displays interface settings for STA 255
MSTP Multiple Spanning Tree Algorithm
Configure Global
Add Configures initial VLAN and priority for an MST instance 258
Show Configures global settings for an MST instance 258
Table 6: Switch Main Menu (Continued)
Menu Description Page