Mvr6 source-port- mode dynamic, Mvr6 source-port-mode dynamic, Mvr6 source-port-mode – LevelOne GTL-2691 User Manual
Page 1250: Dynamic
C
HAPTER
42
| Multicast Filtering Commands
MVR for IPv6
– 1250 –
C
OMMAND
U
SAGE
◆
This command sets the number of times report messages are sent
upstream when changes are learned about downstream groups, and
the number of times group-specific queries are sent to downstream
receiver ports.
◆
This command only takes effect when MVR6 proxy switching is enabled.
E
XAMPLE
Console(config)#mvr6 robustness-value 5
Console(config)#
R
ELATED
C
OMMANDS
mvr6 source-port-
mode dynamic
This command configures the switch to only forward multicast streams
which the source port has dynamically joined. Use the no form to restore
the default setting.
S
YNTAX
[no] mvr6 source-port-mode dynamic
D
EFAULT
S
ETTING
Forwards all multicast streams which have been specified in a profile and
bound to a domain.
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
By default, the switch forwards any multicast streams within the
address range set by a profile, and bound to a domain. The multicast
streams are sent to all source ports on the switch and to all receiver
ports that have elected to receive data on that multicast address.
◆
When the mvr6 source-port-mode dynamic command is used, the
switch only forwards multicast streams which the source port has
dynamically joined. In other words, both the receiver port and source
port must subscribe to a multicast group before a multicast stream is
forwarded to any attached client. Note that the requested streams are
still restricted to the address range which has been specified in a profile
and bound to a domain.
E
XAMPLE
Console(config)#mvr6 source-port-mode dynamic
Console(config)#