LevelOne GTL-2691 - Manual (Page 833)

C HAPTER 25 | SNMP Commands
SNMP Target Host Commands
– 833 –
snmp-server host This command specifies the recipient of a Simple Network Management
Protocol notification operation. Use the no form to remove the specified
host.
S YNTAX
snmp-server host host-addr [inform [retry retries |
timeout seconds]] community-string
[version {1 | 2c | 3 {auth | noauth | priv} [udp-port port]}
no snmp-server host host-addr
host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
inform - Notifications are sent as inform messages. Note that this
option is only available for version 2c and 3 hosts. (Default: traps
are used)
retries - The maximum number of times to resend an inform
message if the recipient does not acknowledge receipt. (Range:
0-255; Default: 3)
seconds - The number of seconds to wait for an
acknowledgment before resending an inform message. (Range:
0-2147483647 centiseconds; Default: 1500 centiseconds)
community-string - Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you can
set this string using the snmp-server host command by itself, we
recommend defining it with the snmp-server community command
prior to using the snmp-server host command. (Maximum length:
32 characters)
version - Specifies whether to send notifications as SNMP Version
1, 2c or 3 traps. (Range: 1, 2c, 3; Default: 1)
auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy. See "Simple Network Management Protocol" on
page 426 for further information about these authentication and
encryption options.
port - Host UDP port to use. (Range: 1-65535; Default: 162)
D EFAULT S ETTING
Host Address: None
Notification Type: Traps
SNMP Version: 1
UDP Port: 162
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ If you do not enter an snmp-server host command, no notifications
are sent. In order to configure the switch to send SNMP notifications,
you must enter at least one snmp-server host command. In order to