LevelOne GTL-2691 - Manual (Page 1277)

C HAPTER 42 | Multicast Filtering Commands
MLD (Layer 3)
– 1277 –
the robustness value is set to zero, meaning that this device will not
advertise a QRV in any query messages it subsequently sends.
E XAMPLE
Console(config-if)#ipv6 mld robustval 3
Console(config-if)#
ipv6 mld static-
group
This command statically binds multicast groups to a VLAN interface. Use
the no form to remove the static mapping.
S YNTAX
ipv6 mld static-group group-address [source source-address]
no ipv6 mld static-group [group-address [source source-address]]
group-address - IPv6 multicast group address. (Note that link-local
scope addresses FF02:* are not allowed.)
source-address - IPv6 source address for a multicast server
transmitting traffic to the corresponding multicast group address.
D EFAULT S ETTING
None
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
◆ If a static group is configured for an any-source multicast (*,G), a
source address cannot subsequently be defined for this group without
first deleting the entry.
◆ If a static group is configured for one or more source-specific multicasts
(S,G), an any-source multicast (*,G) cannot subsequently be defined
for this group without first deleting all of the associated (S,G) entries.
◆ Use the no form of this command without specifying a group address to
delete all any-source and source-specific multicast entries.
◆ Use the no form of this command to delete a static group without
specifying the source address to delete all any-source and source-
specific multicast entries for the specified group.
◆ The switch supports a maximum of 64 static group entries.