LevelOne GTL-2691 - Manual (Page 1548)

C HAPTER 50 | Multicast Routing Commands
General Multicast Routing
– 1548 –
This example lists all entries in the multicast table in summary form:
Console#show ip mroute summary
IP Multicast Forwarding is enabled
IP Multicast Routing Table (Summary)
Flags: F – Forwarding, P - Pruned
Group Source Source Mask Interface Owner Flags
--------------- --------------- --------------- ---------- ------- ------
224.0.17.17 192.168.2.1 255.255.255.255 VLAN2 PIM-DM F
Total Entry is 1
Console#
IPv6 Commands
ipv6 multicast-
routing
This command enables IPv6 multicast routing. Use the no form to disable
IP multicast routing.
S YNTAX
[no] iv6p multicast-routing
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ This command is used to enable IPv6 multicast routing globally for the
router. A multicast routing protocol also needs to be enabled on the
interfaces that will support multicast routing using the router pim6
command, and then specify the interfaces that will support multicast
routing using the ipv6 pim command.
◆ To use multicast routing, MLD proxy can not enabled on any interface of
the device (see ipv6 mld proxy on page 1282 ).
RPF neighbor
IP address of the multicast router immediately upstream for this
group.
Outgoing interface
list and flags
The interface(s) on which multicast subscribers have been
recorded. The flags associated with each interface indicate:
◆ F (Register flag) - This device is registering for a multicast
source.
◆ P (Pruned) - This route has been terminated.
◆ L (Local) - Downstream interface has received IGMP report
message from host in this subnet.
Table 225: show ip mroute - display description (Continued)
Field Description