LevelOne GTL-2691 - Manual (Page 1402)

C HAPTER 48 | IP Interface Commands
IPv4 Interface
– 1402 –
show arp This command displays entries in the Address Resolution Protocol (ARP)
cache.
C OMMAND M ODE
Normal Exec, Privileged Exec
C OMMAND U SAGE
◆ This command displays information about the ARP cache. The first line
shows the cache timeout. It also shows each cache entry, including the
IP address, MAC address, type (static, dynamic, other), and VLAN
interface. Note that entry type “other” indicates local addresses for this
router.
◆ You can define up to 128 static entries in the ARP cache.
◆ A static entry may need to be used if there is no response to an ARP
broadcast message. For example, some applications may not respond
to ARP requests or the response arrives too late, causing network
operations to time out.
◆ Static entries will not be aged out or deleted when power is reset. You
can only remove a static entry via the configuration interface.
◆ Static entries are only displayed for VLANs that are up. In other words,
static entries are only displayed when configured for the IP subnet of a
existing VLAN, and that VLAN is linked up.
E XAMPLE
This example displays all entries in the ARP cache.
Console#show arp
Arp cache timeout: 1200 (seconds)
IP Address MAC Address Type Interface
--------------- ----------------- --------- -----------
10.1.0.0 ff-ff-ff-ff-ff-ff other VLAN 1
10.1.0.254 00-00-ab-cd-00-00 other VLAN 1
10.1.0.255 ff-ff-ff-ff-ff-ff other VLAN 1
123.20.10.123 02-10-20-30-40-50 static VLAN 2
345.30.20.23 09-50-40-30-20-10 dynamic VLAN 3
Total entry : 5
Console#